This kit car was found in Australia on the Gold Coast as far as I know it was never finished, very rare find!
You could scratch build your very own sports car like this using the kitcar plans system.
This is a Lamborghini ( Known as a d-type Lamborghini replica )
It has the same wheel base as a Countach and the same front windscreen ,
Comes with original kit paperwork AND
ENGINEERS TORSIONAL TESTS ON THE SPACE FRAME CHASSIS , (COMPLIANT WITH AUSTRALIAN STANDARDS )
2 OF THESE CARS HAVE BEEN REGISTERED PREVIOUSLY , THE BRAKE AND LANE CHANGE TESTS ARE ALL REQUIRED TO PASS FOR REGISTRATION IN QLD ,not sure about other states, Rules very similar i am told .
Insurance market value of this car finished is $97,000,oo
Car is in 2 pack clear over base original Lamborghini 1997 red (paint job cost $6800)
New Windscreen supplied (cost $900) side glass supplied .
details of manufacturer supplied upon sale and relevant contacts to have finished
MOTOR and ACCESSORY’S
Engine is a Toyota 4litre Quad cam alloy v8 motor has done 32000km
Has polished tappet covers and balance tube . (cost $280)
Custom made 44mm mandrell bent extractors (cost $1250)
Custom made semi polished 2 &1/2 inch S/S mandrell bent exhaust system with S/S cats and resonator and mufflers (cost $1500)
Microtech LT8S EFI computer with dash mount adjustable controller ( cost $2600)
Microtech computer fitted and wired to engine and ignion & front mounted battery compartment (cost $1400)
Bosch fuel pump , Polished fuel swirl pot .(cost $300)
Cams replaced with billeted lumpy cams (cost $800)
Quad core radiator plumbed and rubber mounted (cost $630)
14inch craig davies thermo fan fitted (cost $380)
Engine Runs sweet as , sounds like a formula 1 motor .Starts first pop every time
GEARBOX / TRANSAXEL
Gearbox / Transaxal is renault T-30 5 speed ,very tough box , (billet adaptor plate to motor (cost $850 ) )
Has commodore hsv clutch plate and suburu wrx pressure Plate (very strong combination) (cost $700)
Custom made lightened flywheel to suit adapt toyota 1uzef motor to renault gearbox ( cost $950)
gear shifter fitted and supplied with cables custom made (cost $280) just need mounting plates
Clutch slave cyl supplied , needs master clyinder and booster fitted and bungee hosed together.
Car comes with coil over adjustable springs and polished adjusters (cost $900)
also supplied is pair Koni adjustable height and tension /rebuildable shocks and springs (cost $800)
Brembo big red brake callipers ,Front and rear ( cost $3200)
Has rubbers for most areas
Motor and gearbox fitted to engineers specs , Just turn the key to start ,
custom accelerator cable (cost $70)
Bonnet and boot latches supplied (need fitting )
Suicide doors fitted ,extremely solid hinge system , Latches and locking mechanisms fitted ,electric latches supplied.
Alloy race foot pedals and pedal system fitted
Adjustable height steering colum fitted and Ignion wired into motor and fuel pump .
Car comes with fiberglass pop up light inserts and inner guards and rear wheel tubs
Interior is all in fiberglass , Speco race seats fitted with adjustable runners , ( just needs fitting out then leather covered)
All New gauges supplied VDO quality gauges , 300 kmh speedo , 8 grand Tacho , fuel , turbo , temp , oil psi (cost $1600)
comes with standard seat belts and red 4 point racing harnesses ( cost $290)